Table of Contents
Advertisement
Automation
Section 3 The AutoSampler Module
Figure 3-6 Column Selector Module Y-axis arm
3-4
Note
The smaller piece of tubing from Step 4 is resistant to chemical
corrosion, but the larger piece is not. When inserting the tubing
into the wash solution, be sure only the smaller piece of tubing
is resting inside the solution.
6. Carefully unpack the Z-Drive.
7. Find the Y-axis carriage on the arm of the AutoSampler
Module. The Z-Drive will be attached to this carriage.
8. Slide the Z-Drive onto the arm until the two holes align
with the matching holes in the Y-axis carriage.
Advertisement
Table of Contents
