Table of Contents
Advertisement
Automation
Section 2 The AutoInjector Module
Figure 2-5 Waste tubing fitting attached to the EZ Prep
inject valve
Figure 2-6 Waste fitting with the plastic ferrule removed
2-4
11. Turn the plastic ferrule until it is attached hand tight to
the valve.
12. Turn the steel fitting
13. Remove the plastic ferrule while leaving the fitting
attached.
14. Attach the supplied tubing from this package to the
secured fitting. Tighten the ferrule finger tight with the
supplied tool. Ensure the tubing and fitting are snug in the
EZ Prep inject valve.
1
/
turn tighter.
2
Advertisement
Table of Contents
