Table of Contents
Advertisement
Automation
Section 4 The Column Selector Module
Figure 4-17 Removing the waste line from the EZ Prep
inject valve
Figure 4-18 AutoInjector Module attached to the EZ Prep
column mount
4-10
5. Install the AutoInjector Module by placing it on top of the
prep column mount and pressing downwards. The tab on
the bottom of the AutoInjector Module will snap into the
receptacle on the top of the prep column mount.
6. Connect the USB cable from the AutoInjector Module to
the USB port on the rear of the EZ Prep. If you have a
CombiFlash Rf+ PurIon
EZ Prep, you will need to obtain a USB hub to connect both
modules.
7. Connect the included power supply from the AutoInjector
Module to a suitable power connection. Use a power supply
TM
Mass Detector attached to the
Advertisement
Table of Contents
