Table of Contents
Advertisement
Platinum/Optima
This section describes how to operate the
sampler. These instructions assume that the
sampler has been correctly installed (Section 2),
configured, and programmed (Section 3).
4.1 Start a Sampler Program
Before starting a program:
• Verify the sample tube is connected to the
sample.
• Place empty bottles in the rack and
install on the sequential drive table.
To start the program from the R
press the F1 R
the sampler will need to be calibrated (See
Section 4.1.1) to ensure volume accuracy.
If a sampler configured for multiple bottles was
previously stopped (see Section 4.2), the
sampler will rotate the bottles to number 1
position upon starting.
CVE Refrigerated
Section 4 Operation
button. Upon initial setup,
UN
Sampler
screen,
EADY
4-1
Advertisement
Table of Contents
