Table of Contents
Advertisement
Automation
Section 2 The AutoInjector Module
Figure 2-2 Removing the Luer fitting from the EZ Prep
inject valve
Figure 2-3 Removing the waste line from the EZ Prep
inject valve
2-2
4. Remove the waste line from the EZ Prep inject valve.
Remove the check valve from this line and set it aside for
later use. Discard the waste line.
5. Install the AutoInjector Module by placing it on top of the
prep column mount and pressing downwards. The tab on
the bottom of the AutoInjector Module will snap into the
receptacle on the top of the prep column mount.
Advertisement
Table of Contents
