Table of Contents
Advertisement
Automation
Section 3 The AutoSampler Module
Figure 3-9 Probe clamps inserted into the Z-axis slider
Figure 3-10 Probe inserted into the Z-axis slider
Mounting the AutoInjector
Module
3-6
11. Insert the probe into the hole in the top of the Z-axis slider
and through the holes of the loosened probe clamps.
12. Move the Z-Drive to the topmost position on the Z-axis.
13. Guide the probe down until the tip of the probe is level
with the bottom of the Z-Drive, and then tighten the probe
clamps with your hands.
14. Install the AutoInjector Module onto the AutoSampler
Module by removing the upper-left and lower-right mount-
ing screws on the AutoSampler Module back panel.
Advertisement
Table of Contents
