Table of Contents
Advertisement
Figure 2-11 Sample tube fitting attached to the EZ Prep
inject valve
Figure 2-12 Sample tube fitting with the plastic ferrule
removed
21. Turn the plastic ferrule until it is attached hand tight to
the valve.
22. Turn the steel fitting
23. Remove the plastic ferrule while leaving the fitting
attached.
24. Attach the supplied tubing from this package to the
secured fitting by screwing the new plastic ferrule into the
fitting. Tighten the ferrule finger tight with the supplied
tool.
Section 2 The AutoInjector Module
1
/
turn tighter.
2
Automation
2-7
Advertisement
Table of Contents
