Table of Contents
Advertisement
Automation
Section 3 The AutoSampler Module
Figure 3-20 Sample probe tube fitting with the plastic
ferrule removed
Figure 3-21 Sample probe tube fitting with sample probe
tubing attached
3-12
8. Remove the plastic ferrule while leaving the fitting
attached.
9. Attach the supplied sample probe tubing from this package
to the secured fitting by screwing the new plastic ferrule
into the fitting. Tighten the ferrule finger tight with the
supplied tool.
Note
The spring attached to the tubing prevents kinks from develop-
ing in the tubing.
10. Secure the probe tubing to the side of the EZ Prep by
removing the housing screw, fitting the tubing bracket to
the screw, and replacing the screw.
Advertisement
Table of Contents
