Managing By Snmp; Out-Of-Band Access - 3Com CoreBuilder 7000 Operation Manual

196 C 9: D
HAPTER EVICE

Managing by SNMP

Out-of-Band Access

M
ANAGEMENT
Table 45 SNMP Traps
Trap
Cold start
Link up
Link down
Module configuration change
(port-board up/down/out)
Power supply configuration change
(up/down/out)
Temperature sensor (good/bad)
You can manage the CoreBuilder 7000 family ATM switch via
SNMP-based external network management applications running on a
workstation (see Figure 60). The 3Com Transcend
the recommended graphical user interface tool for central management
of medium to large-scale ATM networks.
Since the agent is standard-based, other SNMP-based applications, such
as SunNet Manager and HP OpenView can be used, provided that the
MIB is correctly installed at the management station.
The CoreBuilder 7000 family ATM switch implements the SNMP agent by
out-of-band access via the Ethernet port.
Use the LMA to configure the CoreBuilder 7000 family ATM switch's IP
address, subnet mask, NMS IP address, and the default gateway via the
LM to enable access to the SNMP agent. Refer to the Installation and
Startup Guide for additional configuration information.
Description
A coldStart trap signifies that the
sending protocol entity is re-initializing
itself such that the agent's configuration
or the protocol entity implementation
may be altered.
A linkUp trap signifies that the sending
protocol entity recognizes that one of
the communication links represented in
the agent's configuration has come up
A linkDown trap signifies that the
sending protocol entity recognizes a
failure in one of the communication links
represented in the agent's configuration
Sent whenever an IFC (interface card) is
inserted or removed from the chassis
Sent whenever a power supply is
disconnected, inserted, or removed from
the chassis
Sent whenever the temperature on the
switch board exceeds a certain
hard-coded limit.
Enterprise Manager is
©