Pnni Routing; Organizing A Network Hierarchy - 3Com CoreBuilder 7000 Operation Manual

PNNI Routing

Organizing a
Network Hierarchy


Switch D now has a decision to make. It does not know that Switch B
is connected to Switch A. Switch D can either send the signal to
Switch F or to Switch B.


Should it choose to send to F (as shown in number 3), then Switch F
will send the signal to E (as shown in number 4).


Switch E does not know that it is the source of the signal, so it sends
the signal to Switch C and the loop will continue until Switch D sends
to Switch B, or until the maximum hops are reached.
With PNNI, looping will not occur, because each node in the network
knows about all the other nodes in the network. See Chapter 13 in the
Management Guide for details on how to prepare the CoreBuilder 7000
for PNNI functions. Also see the CoreBuilder
Installation & Setup Guide for information on activating the PNNI option
during initial setup.
This section will cover the topological structures used in building a PNNI
network. The following topics are covered:

Organizing a Network Hierarchy

Information Exchange in PNNI


Uplinks in a Hierarchy
PNNI allows you to work in a hierarchical structure. Although this chapter
will explain how to create a hierarchy, is not necessary to build a hierarchy
in order to reap all the benefits of PNNI. A PNNI network is based on
nodes. Each node is identified by its node ID. This ID is an ATM address
which identifies the node and the peer group to which it belongs. The
ATM address for the node is created when the switch is set up and
configured. See the Installation & Setup Guide for fast setup instructions.
In order to create a hierarchical network, the network manager needs to
organize the network into groups. These groups can comprise a floor,
building, department or an entire campus. The network manager will also
have to make sure that the segmentation is scalable and will designate
which nodes will belong to which group. These groups are called peer
groups and are identified by the same peer group ID. This ID is defined as
a prefix of up to 13 bytes on an ATM End System Address, which is
assigned to the group by the network manager when the switch is set up.
PNNI Routing
®
7000 Family ATM Switches
71