3Com CoreBuilder 7000 Operation Manual page 46

46
C 2: N
HAPTER ETWORK
I M
NTERFACE ANAGEMENT
Table 10 Setting Interface Type for 3Com Switch/ILMI 3.X Peer (continued)
Peer
My Configured Configured
Interface Type Interface Type
E-IISP IISP
IISP E-IISP
If the peer is running E-IISP, the IME type is determined automatically as
shown in Table 11 but if the peer is running IISP you need to configure
the local switch by LMA. For more information on configuring the local
switch by LMA, see "Display Signaling Protocol Version" on page 203 in
the Management Guide. Table 11 shows how this is done.
Table 11 Auto-Configuration of IME Type for 3Com Switch/ILMI 3.X/E-IISP Peer
Compare My Parameter
with Peer's
my network prefix larger
my network prefix smaller Network-Side
Table 12 Setting IME Type for 3Com Switch/ILMI 3.X/IISP Peer
My Resulting IME Type
If peer is Network-Side, set to
User-Side by LMA
If peer is User-Side, set to
Network-Side by LMA
Non-3Com Switch Peer
When the peer switch is not a 3Com switch, IISP is the protocol used.
Auto-discovery does not operate and the UNI factory default is not
automatically reset to E-IISP. In this case, you need to reset the interface
type via LMA to IISP in both switches. For more information on resetting
the interface, see "Update Port Interface Type" on page 123 in the
Management Guide. Table 13 shows how this is done.
My Resulting
Interface Type
E-IISP
Set to E-IISP
manually
My Resulting IME Type
User-Side
Peer Resulting IME Type
Network-Side
User-Side
Peer Resulting
Interface Type
Set to E-IISP
manually
E-IISP
Peer Resulting IME Type
Network-Side
User-Side