Table 10-2: Quick Setup Parameters - M1 ➔ G1.1 - Johnson Controls VSD Series User Manual

Eaton Technology
Powered by
November 2009
Parameter Lists
On the next pages you will find the lists of parameters within the respective parameter
groups. The parameter descriptions are given by ID number in Chapter 15.
Column explanations:
Code
Parameter
Min.
Max.
Unit
Default
ID
Quick Setup Parameters — M1 ➔ G1.1
Table 10-2: Quick Setup Parameters — M1 ➔ G1.1
Code Parameter
P1.1.1 Min Frequency
P1.1.2 Max Frequency
P1.1.3 Acceleration
Time
P1.1.4 Deceleration
Time
P1.1.5 Motor NP Voltg
P1.1.6 Motor NP Freq
P1.1.7 Motor Nom
Speed
P1.1.8 Motor Nom
Currnt
P1.1.9 Power Factor
P1.1.10 Service Factor
P1.1.11 Current Limit
P1.1.12 Start Srce Hand
LIT-1201828
= Location indication on the keypad; Shows the operator the present
parameter number
= Name of parameter
= Minimum value of parameter
= Maximum value of parameter
= Unit of parameter value; Given if available
= Value preset by factory
= ID number of the parameter for reference to Chapter 15
Min. Max.
0.00 Max_
Frequency
FreqMin 320.00
0.1 3000.0
0.1 3000.0
180 Motor
VoltageMax
8.00 320.00
24 20000
Motor Motor
CurrentMin CurrentMax
0.30 1.00
0.10 2.00
Motor Motor
CurrentMin CurrentMax
1 3
For more information visit: www.johnsoncontrols.com
ID
Unit Default Number Description
Hz 12.00 101
Hz 60.00 102
s 60.0 103
s 60.0 104
V 400 105
Hz 60.00 106
rpm 1720 111
A 5.40 108
0.85 109
1.00 110
A 7.00 107
1 112
VSD Series Drives User Manual
Minimum output frequency,
f[Hz].
Maximum output frequency,
f[Hz].
Time from 0 Hz to maximum Hz.
Time from maximum Hz to 0 Hz.
Motor nameplate voltage in
Volts.
Motor nameplate frequency in
Hertz.
Motor nameplate speed in Rpm.
Motor nameplate current, I[A]
Motor power factor. (Cos Phii)
Motor service factor. This will
calculate the motor current limit.
(MotorNomCurrent x Service
Factor)
Output current limit of the unit in
Amps.
Parameter for Local Start/Stop/
Reverse control location.
Default = Keypad
1 = Keypad
2 = DI-1 Start
3 = I/O Three Wire
10-3