M120 Multiservice Edge Router Hardware Guide
Reinstalling the Fan Trays
148
Figure 45: Reinstalling a CFPC After Installing the M120 Router
To reinstall the fan trays (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point. See the instructions for your site.
Grasp the fan tray by its handle and insert it straight into the chassis. Note the correct
2.
orientation by the "this side up" label on the top surface of the fan tray.
Tighten the captive screw on each side of the fan tray faceplate to secure it in the
3.
chassis.
Lower the cable management system back into position, if necessary.
4.
Repeat the procedure to reinstall the remaining fan trays.
5.
Figure 46 on page
149):
Copyright © 2018, Juniper Networks, Inc.