Reinstalling T320 Front Fan Trays; Reinstalling The T320 Cable Management System; Figure 58: Reinstalling A Front Fan Tray - Juniper Core Router T Series Hardware Manual

Reinstalling T320 Front Fan Trays

Reinstalling the T320 Cable Management System

Related
Documentation
Copyright © 2018, Juniper Networks, Inc.
To reinstall the standard front fan trays (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point. See the instructions for your site.
Grasp one of the fan trays by its handles and insert it straight into the chassis.
2.
Tighten the captive screw on each side of the fan tray faceplate to secure it in the
3.
chassis.
Repeat the procedure to reinstall the remaining fan tray.
4.

Figure 58: Reinstalling a Front Fan Tray

To reinstall the cable management system:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Position the cable management system on the studs on the lower front of the chassis.
2.
Insert the nuts through the holes in the cable management system onto the studs on
3.
the chassis.
Using a 3/8-in. nut driver, tighten the nuts securely.
4.
Preventing Electrostatic Discharge Damage to a T320 Router on page 330
T320 Flexible PIC Concentrators (FPCs) Description on page 61
Chapter 18: Installing the T320 Without a Mechanical Lift
Figure 58 on page 149):
149