Connecting Power To A Dc-Powered M120 Router - Juniper M120 Hardware Manual

Related
Documentation

Connecting Power to a DC-Powered M120 Router

Copyright © 2018, Juniper Networks, Inc.
Installing an M120 AC Power Supply on page 242
Electrical Specifications for the M120 AC Power Supply on page 95
M120 AC Power Supply Description on page 72
M120 Power Supply LEDs on page 73
You connect DC power to the router by attaching power cables from the DC power sources
to the terminal studs on the power supply faceplates. To connect power to the router,
you must provide power cables (cable lugs are supplied with the router). For power cable
specifications, see "M120 DC Power, Connection, and Cable Specifications" on page
To connect the DC source power cables to the router:
Ensure that the voltage across the DC power source cable leads is 0 V and that there
1.
is no chance that the cable leads might become active during installation.
Secure the power cable lugs to the terminal studs, first with the flat washer, then with
2.
the nut (see Figure 59 on page
(1.7 Nm) of torque to each nut.
Attach the positive (+) DC source power cable lug to the
a.
Attach the negative (–) DC source power cable lug to the
b.
Loosen the captive screw on the cable restraint on the lower edge of the power supply
3.
faceplate.
Connect each DC power cable to the appropriate external DC power source.
4.
NOTE: For information about connecting to external DC power sources,
see "M120 DC Power, Connection, and Cable Specifications" on page
Chapter 21: Providing Power to the M120
170). Apply between 12 lb-in. (1.4 Nm) and 15 lb-in.
97.
(return) terminal.
RETURN
(input) terminal.
–48V
97.
169