Connecting The M120 To External Devices; Tools And Parts Required To Connect The M120 Router; Connecting The M120 Router To Management And Alarm Devices; Device - Juniper M120 Hardware Manual

CHAPTER 20

Connecting the M120 to External Devices

Tools and Parts Required to Connect the M120 Router

Related
Documentation

Connecting the M120 Router to Management and Alarm Devices

Copyright © 2018, Juniper Networks, Inc.
Tools and Parts Required to Connect the M120 Router on page 153
Connecting the M120 Router to Management and Alarm Devices on page 153
Connecting the M120 Router to a Network for Out-of-Band Management on page 160
Connecting the M120 Router to an External Alarm-Reporting Device on page 161
Connecting the M120 Router to an External Clocking Device on page 163
Connecting PIC Cables to the M120 Router on page 164
To connect the router to management devices and PICs and to power on the router, you
need:
Phillips (+) screwdrivers, numbers 1 and 2
2.5-mm flat-blade (-) screwdriver
7/16-in. hexagonal-head external drive socket wrench, or nut driver, with a torque range
between 23 lb-in. (2.6 Nm) and 25 lb-in. (2.8 Nm), for tightening nuts to terminal studs
on the circuit breaker box (on a DC-powered router)
Wire cutters
Electrostatic discharge (ESD) grounding wrist strap
M120 Power Supplies Description on page 71
Connecting the Grounding Cable to the M120 Router on page 151
General Electrical Safety Warnings for Juniper Networks Devices on page 339
Connecting the M120 Router to Management and Alarm Devices on page 153
Connecting PIC Cables to the M120 Router on page 164
For management and service operations, you connect the Routing Engine to an external
console or management network through ports on the Craft Interface. You can also
153