Connecting The M120 Router To A Network For Out-Of-Band Management; Figure 54: M120 Routing Engine Ethernet Cable Connector - Juniper M120 Hardware Manual

M120 Multiservice Edge Router Hardware Guide

Connecting the M120 Router to a Network for Out-of-Band Management

160
To connect the Routing Engine to a network for out-of-band management, connect an
Ethernet cable with RJ-45 connectors to the
such cable is provided with the router. For cable specifications, see
Interface Cable and Wire Specifications for the M120 Router" on page
Routing Engine to a network for out-of-band management:
Turn off the power to the management device.
1.
Plug one end of the Ethernet cable
2.
the appropriate ETHERNET
device ports on the CIP. The ports labeled
the upper Routing Engine slot (
Routing Engine in the lower Routing Engine slot (
Plug the other end of the cable into the network device.
3.

Figure 54: M120 Routing Engine Ethernet Cable Connector

port on the craft interface. One
ETHERNET
(Figure 51 on page 157
port on the CIP. Figure 52 on page 157
connect to the Routing Engine in
HOST 0
), and the ports labeled
RE 0
RE 1 ).
Copyright © 2018, Juniper Networks, Inc.
"Routing Engine
105. To connect the
shows the connector) into
shows the external
connect to the
HOST 1