Tools And Parts Required To Remove Components From An M120 Router; Packing The M120 Router For Shipment - Juniper M120 Hardware Manual

M120 Multiservice Edge Router Hardware Guide

Tools and Parts Required to Remove Components from an M120 Router

Related
Documentation

Packing the M120 Router for Shipment

306
Description of the failure
The support representative validates your request and issues an RMA number for
4.
return of the component.
Pack the component for shipment.
5.
To remove components from the router or the router from a rack, you need the following
tools and parts:
2.5-mm flat-blade (–) screwdriver, for detaching alarm relay terminal block
3/8–in. nut driver
Blank panels to cover empty slots
Electrostatic bag or antistatic mat, for each component
Electrostatic discharge (ESD) grounding wrist strap
Flat-blade (–) screwdriver
Mechanical lift, if available
Phillips (+) screwdrivers, numbers 1 and 2
Rubber safety cap for fiber-optic interfaces or cables
Wire cutters
Packing the M120 Router for Shipment on page 306
Displaying M120 Router Components and Serial Numbers on page 297
Contacting Customer Support on page 295
Guidelines for Packing M120 Components for Shipment on page 308
To pack the router for shipment:
Retrieve the shipping crate and packing materials in which the router was originally
1.
shipped. If you do not have these materials, contact your Juniper Networks
representative about approved packaging materials.
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
2.
ESD points on the chassis.
On the console or other management device connected to the master Routing Engine,
3.
enter CLI operational mode and issue the following command to shut down the router
Copyright © 2018, Juniper Networks, Inc.