Replacing An M120 Cfpc; Removing An M120 Cfpc - Juniper M120 Hardware Manual

Related
Documentation

Replacing an M120 CFPC

Removing an M120 CFPC

Copyright © 2018, Juniper Networks, Inc.
Troubleshooting M120 FPCs and CFPCs on page 287
Removing an M120 FPC on page 213
M120 Flexible PIC Concentrators (FPCs) Description on page 51
Troubleshooting M120 FPCs and CFPCs on page 287
The router holds up to two CFPCs, which are installed vertically in the front of the router.
The CFPCs are hot-insertable and hot-removable. When you remove a CFPC, the router
continues to function. Each CFPC weighs approximately 2 lbs. (0.9 kg.) To replace a
CFPC, perform the following procedures:
Removing an M120 CFPC on page 219
Installing an M120 CFPC on page 221
To remove a CFPC (see Figure 87 on page
Have ready a replacement CFPC or a blank panel and an antistatic mat for the CFPC.
1.
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
2.
ESD points on the chassis.
Use one of the following methods to take the CFPC offline:
3.
Press and hold the CFPC online/offline button. The green
button begins to blink. Hold the button down until the LED goes out. The LEDs and
online/offline button for each FPC are located directly above it on the craft interface.
Issue the following CLI command:
user@host>request chassis fpc slot slot-number offline
For more information about the command, see the
Remove the cable from the transceiver on the CFPC faceplate.
4.
Pull the lower end of the ejector lever away from the CFPC faceplate to unseat the
5.
CFPC.
Continue to pull the lever toward you and slide the CFPC straight out of the card cage
6.
halfway.
Chapter 27: Replacing Line Card Components
220):
STATUS
CLI Explorer
LED next to the
.
219