Figure 58: Connecting Ac Power To The M120 Router - Juniper M120 Hardware Manual

M120 Multiservice Edge Router Hardware Guide
168
Reinstall the cable restraint by tightening its retainer screw part of the way into the
7.
power supply faceplate.
Carefully pull the AC power cords through the cable restraint until you have the desired
8.
amount of slack in the power cord.
Tighten the cable restraint retainer screw to hold the power cords in place.
9.
Insert the power cord plugs into an AC power source receptacle. Verify that the power
10.
cord does not block access to router components or drape where people could trip
on it.
NOTE: Each AC power supply has two AC appliance inlets. Each power
supply must be connected to a dedicated AC power feed. For 100-120
VAC, both inlets are used. For 200-240 VAC, only the top inlet is used. For
information about site power preparations, see
Requirements" on page

Figure 58: Connecting AC Power to the M120 Router

"M120 Router Power
88.
Copyright © 2018, Juniper Networks, Inc.