Copyright © 2018, Juniper Networks, Inc.
Do not stack FPCs on top of one another after removal. Place each one
individually in an electrostatic bag or on its own antistatic mat on a flat,
stable surface.
If necessary, remove each installed PIC from the FPC. For information on removing a
9.
PIC, see
"Removing an M120 PIC" on page
After you remove each PIC, immediately place it on an antistatic mat or in an
10.
electrostatic bag.
If you are not reinstalling a FPC into the emptied FPC slot within a short time, install
11.
a blank FPC panel over the slot to maintain proper airflow in the FPC card cage.
CAUTION:
After removing an FPC from the chassis, wait at least 30
seconds before reinserting it, removing an FPC from a different slot, or
inserting an FPC into a different slot.
Figure 84: Removing an M120 FPC
Chapter 27: Replacing Line Card Components
223.
215