Juniper M120 Hardware Manual page 263

See Also
Related
Documentation
Copyright © 2018, Juniper Networks, Inc.
Slide the transceiver until the connector is seated in the PIC or CFPC slot. If you are
5.
unable to fully insert the transceiver, make sure the connector is facing the right way.
Remove the rubber safety cap from the transceiver and the end of the cable. Insert
6.
the cable into the transceiver.
Verify that the status LEDs on the PIC faceplate indicate that the SFP or XFP is
7.
functioning correctly. For more information about the PIC LEDs, see the PIC description
for the PIC in the M120 Multiservice Edge Router Interface Module Reference. You can
also verify PIC functioning by issuing the
described in "Maintaining M120 PICs and PIC Cables" on page
M120 Router Chassis Description on page 7
Overview of Troubleshooting Resources for the M120 Router on page 283
Removing an SFP or XFP Transceiver on page 234
M120 Router Chassis Description on page 7
Overview of Troubleshooting Resources for the M120 Router on page 283
Chapter 27: Replacing Line Card Components
show chassis fpc pic-status
275.
command
237