Calculation Application Selection - Panasonic HG-S Series User Manual

FUNCTION SETTINGS

5-4-2 Calculation Application Selection (

When calculation mode is set to "CALC", the calculation application selection setting can be
configured.
This setting lets you select the application that is used for calculation.
The function of each application is shown below.
Application
Maximum value
(MAX)
Minimum value
(MIN)
Flatness (FLAT)
Average value
(AVERAG)
Standard difference
(STAND)
Torsion (TORSIN)
Curvature
(CURVEA)
Thickness (THICK)
The CALC status mark lights on a controller that is performing calculation.
<Reference>
If more than the specified number of slave units are connected when "TORSIN" (torsion),
"CURVEA" (curvature), or "THICK" (thickness) is selected, the specified number of slave units
closest to the master unit will be used for calculation.
Slave units other than those units will not be used.
5-78
Determines the maximum value of the measured values of the connected
controllers.
Determines the minimum value of the measured values of the connected
controllers.
Extracts the maximum value and the minimum value from the measured
values of the connected controllers, and subtracts the minimum value from
the maximum value.
[Calculated value] = [Max. value] - [Min. value]
Sums the measured values of the connected controllers and divides the re-
sult by the number of controllers.
[Calculated value] = ([Master unit] + [Slave unit 1] + ... + [Slave unit n] ÷ (1+n)
This calculation is performed on the measured value of a connected slave
unit and the master unit.
The measured value of the master unit is subtracted from the measured
value of the slave unit. The result is output from the slave unit.
[Calculated value] = [Slave unit n] - [Master unit]
Measures four locations and calculates the amount of torsion. The result is
the calculated value.
[Calculated value] = ([Master unit] - [Slave unit 1] - [Slave unit 3] - [Slave
unit 2])
Measures three locations and calculates the amount of curvature. The result
is the calculated value.
[Calculated value] = ([Master unit] + [Slave unit 2]) ÷ 2 - [Slave unit 1]
The measured object is pressed from above and below by the master unit
and a slave unit, and the measured values of the master unit and slave unit
are summed.
[Calculated value] = [Master unit] + [Slave unit 1]
)
Function
© Panasonic Industrial Devices SUNX Co., Ltd. 2019
Number of
slave units
1 unit or
more
1 unit or
more
1 unit or
more
1 unit or
more
1 unit or
more
3 units
2 units
1 unit