Panasonic HG-S Series User Manual page 24

INSTALLATION AND CONNECTIONS
3.
Fasten the sensor head.
When fastening the sensor head, tighten the mounting nut with a wrench while holding the
sensor head in place with the provided sensor head fastening wrench as shown below.
When mounting the sensor head, note that the tightening torque must not exceed the value
shown in the table below.
Sensor head fastening wrench (accessory)
When tightening the mounting nut on the regular type, take care not to damage the rubber bellows.
4.
On the regular type, make sure that the rubber bellows have not become deformed as
shown below.
If the rubber bellows is deformed, rotate the bellows to restore to the normal shape.
If the rubber bellows is deformed, a load will occur when the spindle operates and damage
may result.
3-4
Wrench
© Panasonic Industrial Devices SUNX Co., Ltd. 2019
HG-S1010(R)、HG-S1110(R)
HG-S1010-AC、HG-S1110-AC
HG-S1032
HG-S1050
Tightening torque
12.5N・m
15N・m