Panasonic HG-S Series User Manual page 57

<Reference>
● The default setting for the tolerance is "0.1000" (±0.1).
● For the tolerance setting, refer to "5-2-5 Tolerance <±>".
● Judgment results that appear in the display are described in the table below.
Digital display / MAIN (white)
● If one of the messages in the table below appears in the digital display, teaching did not take
place correctly and an error occurred.
MAIN (white) /
SUB (green)
MAIN (white)
SUB (green)
MAIN (white)
MAIN (white)
SUB (green)
© Panasonic Industrial Devices SUNX Co., Ltd. 2019
Stable measurement can be performed
Stable measurement cannot be performed
Teaching did not take place correctly
Digital display
Display
BASIC OPERATION
Description
Description
Immediately after the power is turned ON or a pre-
set is input
When the upper or lower display limit is exceeded
During alarm output
When an error is output
4-13