Panasonic HG-S Series User Manual page 181

5) For the relationship between supplied air pressure and measuring force or between measuring force
and pushed spindle position, see the figures below. For upward mount without a seal cap, subtract
0.2N from the measuring force. For side mount, subtract 0.1N from the measuring force. The following
figures are only typical examples, and these relationships differ depending on the assembly accuracy of
the product or the abrasion status of sealing materials.
Pushed spindle position [mm]
<Downward mount (typical example)>
Pushed spindle position [mm]
<Upward mount (typical example)>
6) Protective structure is not applicable when the sealing portions have deteriorated or become damaged.
The protection level is zero when the seal cap is removed.
7) Do not use or store this product in environments where ambient air is pressurized to an air pressure
higher than the atmospheric pressure at an altitude of 0 m.
8) Typical value in a clean environment with no contact with dust or liquids such as water and oil.
The sealing material (O-ring) for the seal cap must be replaced at appropriate intervals. For approxi-
mate replacement intervals, refer to "How to replace the seal cap" in "7-4 Replacing the Seal Cap (Air-
Driven Type Only)".
9) The probe is also available as an option.
© Panasonic Industrial Devices SUNX Co., Ltd. 2019
Pushed spindle position [mm]
<Side mount (typical example)>
● When no seal cap is mounted
Pushed spindle position [mm]
<Downward mount (typical example)>
SPECIFICATIONS
6-7