Panasonic HG-S Series User Manual page 176

SPECIFICATIONS
6-1 Specifications
● Controller
Type
NPN output
Model No.
PNP output
Number of connect-
able units
Supply voltage
Current consumption
(Note 2)
Analog current output
(Note 3)
Control output
(Output 1 / Output 2 /
Output 3)
Short-circuit protection
Judgment output
Alarm output
External output
switching
External input
(Input 1 / Input 2 /
Input 3)
Trigger input
Preset input
Reset input
Bank input A / B
External input switching
6-2
Master unit
High-performance type
HG-SC101
HG-SC101-P
Up to 15 slave units can be connected per master unit.
(When communication unit consolidated: up to 14 slave units)
24V DC ±10%, including 0.5V ripple (P-P)
70mA or less (when sensor head is connected)
• Current output range: 4 to 20mA / F.S.
(default value)
• Error output: 0mA
• Linearity: ±0.25% F.S.
• Load impedance: 250Ω max.
<NPN output type>
NPN open-collector transistor
• Maximum sink current: 50mA (Note 4)
• Applied voltage: 30V DC or less (between output and 0V)
• Residual voltage: 1.5V or less (at 50mA sink current)
• Leakage current: 0.1mA or less
<PNP output type>
PNP open-collector transistor
• Maximum source current: 50mA (Note 4)
• Applied voltage: 30V DC or less (between output and +V)
• Residual voltage: 1.5V or less (at 50mA source current)
• Leakage current: 0.1mA or less
Incorporated (automatic reset type)
NO / NC switching method
Open when alarm occurs
Output 1 / Output 2 / Output 3 can be changed to "HI / GO /
LO", "HI or LO / IN RANGE / ALARM", or "LO / HI / ALARM"
<NPN output type>
Non-contact input or NPN open-collector transistor
• Input condition: Invalid (+8V to +V DC or open)
• Input impedance: Approx. 10kΩ
<PNP output type>
Non-contact input or PNP open-collector transistor
• Input condition: Invalid (0 to +0.6V DC or open)
• Input impedance: Approx. 10kΩ
Input time 2ms or more (ON)
Input time 20ms or more (ON)
Input time 20ms or more (ON)
Input time 20ms or more (ON)
Input 1 / Input 2 / Input 3 can be changed to "Preset / Reset /
Trigger", "Bank Input A / Bank Input B / Select (Preset, Reset,
Trigger)"
HG-SC111
HG-SC111-P
Valid (0 to +1.2V DC)
Valid (+4V to +V DC)
© Panasonic Industrial Devices SUNX Co., Ltd. 2019
Slave unit
Standard type Wire-saving type
HG-SC112
HG-SC112-P
―
HG-SC113
―
―
―
―