Calculation Application Selection - Panasonic HG-T Series User Manual

7.3 Calculation Settings (

7.3.2 Calculation Application Selection (

When "MODE" (calculation mode) is set to "CALC", this function allows you to set calculation
application selection.
You can select an application to be used for calculation.
The function of each application is described in the following table.
Application
Maximum value
(MAX)
Minimum value
(MIN)
Average value
(AVERAG)
Standard difference
(STAND)
Thickness / width
(THICK)
The CALC status mark is lit on the controller that is performing calculations.
● If "THICK" (thickness/width) is selected, when the number of connected slave units is greater
than the specified number, the slave unit nearest the master unit is used for calculation.
Other slave units are not used for calculation.
7-54
)(For Master Units Only)
The maximum value of the measured values of the connected controllers
is used as the calculated value.
The minimum value of the measured values of the connected controllers
is used as the calculated value.
The value obtained by dividing the sum of the measured values of the
connected controllers by the number of controllers is used as the
calculated value.
[Calculated value] = ([Master unit] + [Slave unit 1] +...+ [Slave unit n]) ÷ (1
+ n)
The measured value of each connected slave unit and the measured
value (used as the base) of the master unit are calculated.
The value obtained by subtracting the measured value of the master unit
from the measured value of each slave unit is used as the calculated
value. The calculated value is output from each slave unit.
[Calculated value] = [Slave unit n] - [Master unit]
The value obtained by adding the measured values of the master unit and
slave unit to the measured object is used as the calculated value.
[Calculated value] = [Master unit] + [Slave unit 1]
)
Function
Number of
slave units
required
At least one
unit
At least one
unit
At least one
unit
At least one
unit
One unit
WUME-HGT-6