What You Can Do In The Static Route Screens; The Static Route Screen; Static Route Add/Edit - ZyXEL Communications AMG1302-T series User Manual

Chapter 9 Static Route

9.1.1 What You Can Do in the Static Route Screens

• Use the Static Route screens
on the AMG1302/AMG1202-TSeries.
• Use the IPv6 Static Route screens
routes on the AMG1302/AMG1202-TSeries.

9.2 The Static Route Screen

Use this screen to view the static route rules. Click Network Setting > Static Route to open the
Static Route screen.
Figure 55 Network Setting > Static Route
The following table describes the labels in this screen.
Table 36 Network Setting > Static Route
LABEL
Add new static
route
#
Destination IP
Gateway
Subnet Mask
Metric
Modify

9.2.1 Static Route Add/Edit

Use this screen to add or edit a static route. Click Add new Static Route Entry in the Routing
screen or the Edit icon next to the static route you want to edit. The screen shown next appears.
136
(Section 9.2 on page
(Section 9.3 on page
DESCRIPTION
Click this to configure a new static route.
This is the number of an individual static route.
This parameter specifies the IP network address of the final destination. Routing is always
based on network number.
This is the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward packets to
their destinations.
This parameter specifies the IP network subnet mask of the final destination.
This is the number of transmission hops between this AMG1302/AMG1202-TSeries and
the destination.
Click the Edit icon to go to the screen where you can set up a static route on the
AMG1302/AMG1202-TSeries.
Click the Delete icon to remove a static route from the AMG1302/AMG1202-TSeries. A
window displays asking you to confirm that you want to delete the route.
136) to view and configure IP static routes
137) to view and configure IPv6 static
AMG1302/AMG1202-TSeries User's Guide