Walking Down Stairs; Walking Down A Ramp; Mymodes; Switching Mymodes With The Cockpit App - Otto Bock Genium 3B1 Instructions For Use Manual

10.1.9 Walking down stairs

This function must be practised and executed consciously. Only when the sole is properly
positioned can the system react correctly and permit controlled flexion.
1) Hold the handrail with one hand.
2) Position the leg with the prosthesis on the step so that the foot projects halfway over the
3) Roll the foot over the edge of the step.
4) Place the foot of the other leg onto the next step.
5) Place the foot of the prosthesis leg on the next step after that.
INFORMATION: The flexion speed of the knee joint can be changed using the Cock­
pit app or remote control via the parameter "Resistance" (see Page 82).

10.1.10 Walking down a ramp

Under increased flexion resistance, permit controlled flexion of the knee joint which lowers
the body's centre of gravity.
INFORMATION: The flexion resistance at which the knee bends can be changed
using the Cockpit app or remote control via the parameter "Resistance" (see
Page 82).

10.2 MyModes

In addition to basic mode (mode 1), up to 5 MyModes can be activated and configured with the adjustment soft­
ware. They can be called up by the patient using the Cockpit app or remote control (optional accessory). Only the
first 3 MyModes can be selected using movement patterns. Switching by using motion patterns has to be activated
in the adjustment software.
For information on switching MyModes with the remote control (optional accessory), see the remote control
instructions for use.
These modes are intended for specific motion patterns or postures (e.g. inline skating, ...). Default settings for
these motion patterns and postures can be called up and individually adapted using the adjustment software.
Settings can also be adjusted by the patient using the cockpit app or remote control (see Page 83).

10.2.1 Switching MyModes with the cockpit app

INFORMATION
Bluetooth on the prosthesis must be turned on in order to use the cockpit app.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down or by connecting/discon­
necting the battery charger. Bluetooth is then turned on for approx. 2 minutes. During this time, the app must be
started and used to establish a connection. If required, Bluetooth on the prosthesis can be switched on perman­
ently afterwards (see Page 83).
Once a connection to a prosthesis has been established, the cockpit app can be used to switch between the
MyModes.
Genium 3B1/3B1=ST
edge of the step.
→ This is the only way to assure a secure rollover.
→ This flexes the prosthesis slowly and evenly in the knee joint.
Use
Ottobock | 79