Table of Contents
Advertisement
Basic settings (setup menu and special functions)
With the setting
temperature
automatically. If both sensors are available then the external sensor will be selected
automatically.
The selected sensor can be seen at on the display. The temperature is shown in
the field at the top right; below the ° character an
the external sensor.
If no thermostat jacket but the platform is installed then only the external
temperature sensor is available.
If the selected temperature sensor has not been connected then question marks
appear instead of the temperature.
10.3.4
Language / Sprache
The language in which the parameters and information appears in the display is
entered here. You can choose between
The chosen language is also used for labelling the parameters and measured
values in the printer output and in the data logger add-in of the software LabDesk.
auto
(number 3) the Firmware will automatically check which
sensors
are
available
and
select
the
I
stands for the internal and
English
German
(0) and
page 73
appropriate
sensors
E
for
(1).
Advertisement
Table of Contents
