Fifth Page Of Setup Menu; Password; Set Defaults - kruss K11 MK3 User Manual

Basic settings (setup menu and special functions)
10.5

Fifth page of Setup menu

On the fifth page you have the possibility of protecting access to the Setup menu by
using a password. You can also return all the Setup settings to the default values
defined by KRÜSS.
10.5.1

Password

The password can be used to prevent alterations being made in Setup without your
knowledge and therefore avoid faulty measurements as a result of unsuitable settings.
If you enter a password and then exit Setup, then the password will be requested the
next time that Setup is called up.
!
You must not forget the password. All users who require access to Setup should be
informed of it. Once you have defined a password it is impossible to open Setup
without this password and it is not possible to switch off the password function or
alter the password outside Setup. If the password is lost then you must re-install
the K11 Firmware.
10.5.2

Set defaults

set defaults
Under
defined Setup settings will be used. If
be deleted and the default values defined by KRÜSS will be reset. This takes place
immediately after the selection of
!
There is no possibility of saving the user-defined settings. If you reset the settings
to the default settings then user-defined settings can only be reset be entering them
manually.
you can choose either
Yes
Yes
and not when the
Yes No No
or . If is selected then the user-
is selected then all user-defined settings will
Setup
menu is exited.
page 75