Measurements With The Plate Or Rod Method; Main Menu "Plate Method; Measuring Mode - kruss K11 MK3 User Manual

Measurements with the plate or rod method

7 Measurements with the plate or rod method
Measuring with a rod is assigned to the plate measuring method. When measuring
with a rod the wetted length of the rod used must be entered (
from that, the same instructions as for the plate method apply.
7.1

Main menu "Plate Method"

In order to access the main menu of the plate method press the key
.
The following display appears:
You will find the current settings for measurements with the plate method in the four
lines in the centre. If you want to retain the settings then you can start the
measurement with the ENT-key (for the measurement itself
alterations
To make
.
The entries are confirmed with ENT; you can select between the parameters with the
two vertical arrow keys. ESC exits the
off the alterations are saved and retained when the instrument is switched on again.
7.1.1

Measuring mode

Here you can choose between surface and interfacial tension measurements. (0)
stands for surface tension (
to the settings press the key
Modify
SFT
), (1) for interfacial tension (
ch. 0).
mode. When the instrument is switched
IFT
).
page 39
ch. 7.1.4 ). Apart