Table of Contents
Advertisement
page 50
8.1.3
Reading limit
The result at the end of a measurement is an arithmetic average value calculated from
a certain number of single measurements. This is where you enter the
number of these single measurement values. Ten measurements are usually sufficient.
In case of higher variations this number can be increased.
The number of values that are
deviation (
has been achieved or undercut; the number of values recorded will never exceed
Reading limit
the
Under the main menu item
values to be used for calculating the standard deviation is set. When a
measurement is finished because the deviation conditions were matched, the
average value is calculated not from all values but from the values that were most
recently used for calculating the standard deviation.
8.1.4
Heavy density
For surface tension measurements the density of the liquid to be measured is entered
here; for interfacial tension the density of the heavy phase.
8.1.5
Light density
For surface tension measurements the density of the surrounding gas is entered here.
If the surface tension is measured in air then the value is 0.001g/ml; if you work under
a protective gas (e.g. argon) then the density of the gas must be entered.
For interfacial tension measurements the density of the light phase must be entered.
8.1.6
Relaxation / switching to the ring tear-off mode
Each measured value which is to be recorded in a measurement requires the
maximum force to be determined again. By entering a percentage value for
Relaxation
which the force acting on the ring is to be reduced before a further measurement is
made.
SD
). The measurements will be terminated when this standard deviation
.
Settings Number of values for SD
you are determining the percentage of the measured maximum force by
actually
recorded is ruled by the highest standard
Ring method measurements
maximum
the number of
Advertisement
Table of Contents
