Table of Contents
Advertisement
7.5.6
Store Act Cfg (store actual detected configuration)
This function can only be executed in configuration mode.
This function enables you to store the configuration of all slaves which are connec-
ted and detected on the selected AS-i circuit.
If "Store" was successful, the LED "Config error" is off. The configuration is stored,
the configuration error has been eliminated.
If one of the connected slaves has a peripheral fault, the LED "Config error" will
flash.
-
If the AS
i master is in protected mode, the following error message will appear:
"Failed No Config Mode"
-
If an AS
i slave with address zero exists, storing the configuration will be confirmed
with "OK". However, the configuration error remains because address zero is not
a valid operating address for storing a slave.
7.5.7
Permanent Param (projected parameter)
This function allows you to set the permanent parameters. A list of all slaves is dis-
played from 1A - 31A and from 1B - 31B. The permanent parameters for single
slaves are set from address 1A - 31A. The parameter is shown as a hexadecimal
value behind the slave address.
7.5.8
Permanent Config (projected configuration data)
With this function the projected configuration data can be projected. The values for
the configuration data are displayed behind the slave address in the following or-
der:
IO (I/O-configuration) ID (ID-configuration) xID1 (extended ID1)
xID2 (extended ID2).
Subject to reasonable modifications due to technical advances.
32
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91 · Internet http://www.pepperl-fuchs.com
Operating in Advanced Display Mode
S T O R E A C T U A L
C O N F I G U R AT I O N
S T O R E
P E R A M N E N T PA R A M
I
1 A -
0
2 A -
2
I
3 A -
F
4 A -
E
I
5 A -
3
P E R A M N E N T C O N F I G
I O I D
x I D 1
x I D 2
1 A
-
7 F 3 4
2 A
-
7 F 3 4
AS-Interface
Copyright Pepperl+Fuchs, Printed in Germany
Advertisement
Table of Contents
