Table of Contents
Advertisement
Default: Setting of the ExtDiag flag on peripheral faults disabled.
ExtDiag on Earth Fault
Activates and deactivates setting of the ExtDiag flag on earth (ground) fault.
Default: Setting of the ExtDiag flag on earth fault is disabled.
ExtDiag on Double Address
Activates and deactivates setting of the ExtDiag flag on double address.
Default: Setting of the ExtDiag flag on double address is disabled.
Freeze Diagnosis
The diagnostic data are continuously updated during runtime. If this is not desired,
this parameter can be used to disable continuous updating. Updating then takes
place only when this is required by the PROFIBUS standard.
AS-i Input Change Buffers
Default: Disabled.
Download Slave Parameters
Based on this entry the parameter bits can be downloaded for each AS-i slave.
These are then sent to the connected AS-i slave when the AS-i cycle is started.
Sending of the set parameters bits can be disabled with this value.
Default: Sending of the AS-i parameter bits enabled.
AS-i-Parameter Slave 1/1A...
The parameter bits send to this AS-i slave can be selected in the drop down win-
dow. The settings which are made with the parameters bits can be found in the
data sheet for the corresponding slave.
Subject to reasonable modifications due to technical advances.
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91 · Internet http://www.pepperl-fuchs.com
Appendix: Example for startup on a Siemens S7
AS-i/PROFIBUS-Gateway
Copyright Pepperl+Fuchs, Printed in Germany
149
Advertisement
Table of Contents
