Table of Contents
Advertisement
Meaning of the displayed mode:
Enable:Automatic address programming is released.
Disable:Automatic address programming is locked.
With "Change" the operation mode can be changed.
7.5.12
Factory reset
With this function the master can be reseted to the factory setting. The reset can
be chosen by selecting the menu entry "DO RESET".
• This function should be used only in an emergency, since all attitudes trans-
acted so far are put back to factory setting and thus perfect communication
and functioning of the masters with the AS-i circle are ensured no more.
• The master and the AS-i circuit have to be recommissioned and reprojected
again after a successful "Reset".
• In case of double masters the "Reset" acts on both AS-i masters!
7.6
IO + Param. Test
7.6.1
AS-i circuit
To reach this setup menu you have to change the desired AS-i circuit by using the
arrow and the OK buttons.
The function is only implemented in the double master.
It makes possible to change the AS
rated.
The active circuit is marked by the cursor.
Subject to reasonable modifications due to technical advances.
34
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91 · Internet http://www.pepperl-fuchs.com
Operating in Advanced Display Mode
FA C T O R Y R E S E T
D O R E S E T
A S - I C I R C U I T 1
A S - I C I R C U I T 2
-
i circuit that is currently active for being ope-
AS-Interface
Copyright Pepperl+Fuchs, Printed in Germany
Advertisement
Table of Contents
