Pepperl+Fuchs VBG-PB-K20-DMD-C1 Manual page 31

Afterwards the test is started by confirming the menu entry "Test".
After finishing the test all relevant informations is displayed for the tested slave.
A successful test is displayed with "OK" below the address of the tested slave.
The following information are displayed:
• Address of the tested slave
• Existing errors are indicated
• Binary inputs (digital inputs), see also "Binary input", chapter 7.6.3
• Binary outputs (digital outputs), see also "Binary outputs", chapter 7.6.4
• Analog inputs, see also "Analog inputs", chapter 7.6.5
• Analog outputs, see also "Analog outputs", chapter 7.6.6
• Param (actual parameters), see also "Parameter", chapter 7.6.7
• Perm Param (projected parameters), see also "Permanent Param (projected
parameter)", chapter 7.5.7
• Config (actual configuration), see also "Actual Config (actual configuration)",
chapter 7.7.4
• Perm Conf (projected configuration), see also "Permanent Config (projected
configuration data)", chapter 7.5.8
Subject to reasonable modifications due to technical advances.
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91 · Internet http://www.pepperl-fuchs.com
AS-i/PROFIBUS GatewayAS-i/PROFIBUS-Gateway
Operating in Advanced Display Mode
S L AV E T E S T T O O L
S L AV E A D R
T E S T
S L AV E 1 5 O K
B I N A R Y I N P U T S
0 1
B I N A R Y O U T P U T S
0 1
A N A L O G I N P U T S
0 + 1 7 8 9 8
1 + 3 2 7 6 7 O V E R F L
A N A L O G O U T P U T S
0 + 1 7 8 9
1 + 2 5 0 0
PA R A M
P E R M PA R A M
C O N F I G
P E R M C O N F
2 1 A
F
F
7 F F E
7 F F E
Copyright Pepperl+Fuchs, Printed in Germany
29