Table of Contents
Advertisement
7.1
PROFIBUS(main menu)
7.1.1
PROFIBUS (PROFIBUS Station Address)
P R O F I B U S A D D R E S S
S E T A D D R O V E R P B
I + M S E R V I C E S
P R O F I B U S S TAT U S
This function is used for the setting and changing of the PROFIBUSstation
address.
The number behind "Old Address" shows the actual stationstation address. By sel-
ecting "New Address", this address can be changed.
7.1.2
PROFIBUS Status
The function PROFIBUS Status indicates if and how many connections are active
on each PROFIBUS channel.
DPV0 = cyclic channel:
0:
not active
1:
active
DPV1 = acyclic channel:
0:
not active
≠0: number of connections
7.1.3
SET ADDR OVER PB (Set address over PROFIBUS)
P R O F I B U S A D D R E S S
S E T A D D R O V E R P B
I + M S E R V I C E S
P R O F I B U S S TAT U S
With the help of this function changing the address over the PROFIBUS can be
switched off and on.
• CHANGE: the display changes between ENABLED and DISABLED
DISABLED: address modification over BUS is not possible.
ENABLED: address modification over BUS is possible.
Subject to reasonable modifications due to technical advances.
24
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91 · Internet http://www.pepperl-fuchs.com
Operating in Advanced Display Mode
P R O F I B U S A D D R E S S
O L D A D D R E S S
N E W A D D R E S S
S E T A D D R O V E R P B
D I S A B L E D
C H A N G E
AS-Interface
0 9 9
0 0 3
Copyright Pepperl+Fuchs, Printed in Germany
Advertisement
Table of Contents
