Table of Contents
Advertisement
10.3.5.15 Change slave address (SLAVE_ADDR)
With this call, the AS-i address of an AS-i slave can be modified.
This call is mainly used to add a new AS-i slave with the default address "0" to the
AS-Interface. In this case, the address is changed from "AS-i slave address
old" = 0 to "AS-i slave address new".
This change can only be made when the following conditions are fulfilled:
1. An AS-i slave with "AS-i slave address old" exists.
2. If the old AS-i slave address is not equal to 0, an AS-i slave with address "0"
cannot be connected at the same time.
3. The "AS-i slave address new" must have a valid value.
4. An AS-i slave with "AS-i slave address new" must not exist.
When the AS-i slave address is changed, the AS-i slave is not reset, in other
words, the output data of the AS-i slave are retained until new data are
received at the new address.
byte
1
2
3
4
byte
1
2
Meaning of bit B:
B = 0 Single AS-i slave or A-slave
B = 1 B-slave
Subject to reasonable modifications due to technical advances.
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91 · Internet http://www.pepperl-fuchs.com
7
6
5
2
2
2
T
–
–
B
–
B
7
6
5
2
2
2
T
AS-i/PROFIBUS-Gateway
Command Interface
Request
4
3
2
2
0D
16
circuit
source address
target address
Response
4
3
2
2
0D
16
result
Copyright Pepperl+Fuchs, Printed in Germany
2
1
0
2
2
2
2
1
0
2
2
2
97
Advertisement
Table of Contents
