Pepperl+Fuchs VBG-PB-K20-DMD-C1 Manual page 134

Setting the toggle bit:
Byte 1
Byte 2
Byte 3
Byte 4
...
Byte 12
Byte 1
Byte 2
Byte 3
Byte 4
Byte 5
Byte 6
...
Byte 12
The flag NA has to be set before the application is started. In case it is not set, the
flags have to be read out until this flag has been set to 1.
The flag NA indicates that the master is in normal operation mode.
Normal operation mode is necessary to run the application safely.
If a command of the command interface is used via PROFIBUS DP V1, it is not
necessary to use the toggle bit.
The flag NA indicates that the master is in the normal operating mode which is nec-
essary for the application to run safely.
Subject to reasonable modifications due to technical advances.
132
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91 · Internet http://www.pepperl-fuchs.com
Request: GET_FLAGS
47 (GET_FLAGS)
hex
00 (T = 0, master 1, single master)
hex
00
hex
00
hex
...
00
hex
Response
47
hex
80 (T = 1, result = 0)
hex
- - - -
OR APF NA CA
00
hex
00
hex
Command Interface
- - - POK
AAv AAs S0 COK
AAe OL DX
Copyright Pepperl+Fuchs, Printed in Germany
AS-Interface