Output Eq Function; Eq Param (Eq Parameter) Screen - Yamaha DSP5D Owner's Manual

OUTPUT EQ function

OUTPUT EQ function

EQ PARAM (EQ Parameter) screen

Here you can edit the EQ parameters of the selected out-
put channel.
EQ PARAM
(If a MIX channel or STEREO A/B channel is selected)
EQ PARAM
(If a MATRIX channel is selected)
250
PM5D/PM5D-RH V2 / DSP5D Owner's Manual
1 2
5
A Channel selection
Select the output channel that you want to edit. You
can use eight-band EQ (four UPPER bands + four
LOWER bands) for MIX channels and STEREO A/B
channels, and four-band EQ for MATRIX channels.
If a channel is paired (or if a STEREO A/B channel is
selected), a heart symbol is displayed at the right. For
MIX channels or MATRIX channels, you can click this
symbol to enable/disable pairing.
B EQ ON/OFF (EQ on/off)
Turns the EQ on/off for that channel.
C EQ LINK GROUP
Selects the EQ link group (A–H) to which the EQ of
that channel belongs. EQ parameters are linked for
output channels belonging to the same group.
Note
The EQ of MIX channels and STEREO A/B channels can be
assigned only to groups A–F, and the EQ of MATRIX chan-
nels can be assigned only to groups G/H.
D LIBRARY
This button accesses the OUTPUT EQ LIBRARY
screen (➥ p.252), where you can store/recall EQ
library settings for output channels.
E EQ TYPE
Selects the type of EQ. Turning the TYPE I button on
selects the algorithm used in the 02R series. Turning
the TYPE II button on selects a newly developed algo-
rithm. TYPE II reduces the interference between bands.
F EQ graph
This graph shows the approximate response of the EQ
parameters. The colored vertical lines indicate the
FREQ (center frequency) of the band for the parame-
ter at which the cursor is located. (The color of each
line matches the knob markings for each band.) The
response curve will change when you edit the Q or
GAIN of each band.
G Level meter
These meters indicate the peak levels before EQ and
after EQ. If the signal clips before EQ, the OVER seg-
ment will light.
H EQ FLAT
This button resets the GAIN parameters of all bands to
the default value (±0.0 dB). When you click this but-
ton, a confirmation message will appear.
I LOWER/UPPER (only for MIX channels and
STEREO A/B channels)
This indicator shows which four bands (LOWER or
UPPER) are selected in the SELECTED CHANNEL
section of the panel. The text label of the selected group
is displayed in yellow.
Reference section
3 6 4
9 8 7