Global Functions; Effect Functions; Effect Param (Effect Parameter) Screen - Yamaha DSP5D Owner's Manual

Global functions

EFFECT functions

EFFECT PARAM (Effect parameter)
screen
Here you can select the type of internal effect, edit its
parameters, and perform input/output patching.
EFFECT PARAM
1
2
A Effect selection
Of the internal effects 1–8, select the effect for which
you want to make settings. To switch between effects,
place the cursor here and turn the [DATA] encoder, or
click the / buttons at left or right.
B Effect type
Indicates the currently selected effect type, both by
name and as a graphic. The number of input/output
channels (1 IN/2 OUT or 2 IN/2 OUT) of this effect is
also shown at the bottom of this area.
Note
You can't switch the effect type in this screen. If you want to
switch to a different effect type, recall an effect that uses the
desired effect type from the effect library.
166
PM5D/PM5D-RH V2 / DSP5D Owner's Manual
Global functions
C Input patch
D Input meter
3 4
Reference section
This box lets you select the signal path that will be
patched to the L/R input channels of the internal effect.
Move the cursor to this box and turn the [DATA]
encoder or click the / buttons at left or right to dis-
play the desired signal path, and then press the
[ENTER] key to finalize the change.
You can choose the following signal paths.
MIX1–MIX24 MIX channel 1–24 output
INS CH1–INS CH48 Input channel 1–48 insert out
INS STIN1 (L/R)–INS STIN4 ST IN channel 1–4 (L/R)
(L/R) insert out
INS MIX1–INS MIX24 MIX channel 1–24 insert out
MATRIX channel 1–8 insert
INS MTRX1–INS MTRX8
out
STEREO A channel (L/R)
INS ST A (L/R)
insert out
STEREO B channel (L/R)
INS ST B (L/R)
insert out
INS MON (L/R/C) MONITOR channel (L/R/C)
(PM5D only) insert out
Note
• If you move the cursor away without pressing the [ENTER]
key, the setting will revert to its original state.
• If you assign a signal to both input channels for a 1 IN/2
OUT effect type, the two will be mixed to monaural and then
input.
• If you assign a signal to only one input channel for a 2 IN/2
OUT effect type, the same signal will be sent to both chan-
nels of the effect.
• If STEAL PATCH CONFIRMATION is turned on in the
PREFERENCE 1 screen (UTILITY function), and you
attempt to make patch settings that would cause an existing
patch to be modified, a confirmation message will appear.
Indicates the level of the signal being input to the effect.