Operating The Buttons; Adjusting The Setting Of A Knob Or Fader - Yamaha DSP5D Owner's Manual

Operating the buttons

Buttons in the display are used to switch parameters on/off
or to select one of multiple choices.
Click
➠
Off
1 Move the pointer to the desired button, and
use the left/right buttons of the track pad (or
mouse) to click the button.
The button will be switched on/off (or the correspond-
ing button will be selected).
Hint
You can use the CURSOR [ √ ]/[ ® ]/[ π ]/[ † ] keys and the
[ENTER] key (or the arrow keys and <Enter> key of a PS/2
keyboard) to perform the equivalent operation.
Hint
When using the track pad, you can also click by tapping the
track pad if you have enabled tapping in the PREFERENCE 2
screen (UTILITY function ➥ p.206). In this case, the result will
be the same as if you pressed the left button of the track pad
(or mouse).
Adjusting the setting of a knob or
fader
Knobs and faders in the display are used to adjust the value
of specific parameters.
On
1
2
3
PM5D/PM5D-RH V2 / DSP5D Owner's Manual
Adjust the
knob value
Adjust the
fader value
Move the pointer to the desired knob/fader,
and use the left/right buttons of the track pad
(or mouse) to click the knob/fader.
The cursor will move to that location.
To increase or decrease the value in steps of 1,
click the right button or left button of the
track pad (or mouse).
Clicking the right button will raise the value by one
step, and clicking the left button will lower the value by
one step.
To raise or lower the value continuously, use
the track pad (or mouse) to drag the knob/
fader.
The value will change as you drag the knob or fader
left/right or up/down. For a parameter whose knob has
a wide range of adjustment, holding down the right
button of the track pad (or mouse) as you drag will
produce a larger range of change than when using the
left button.
Hint
You can also adjust the value by using the [DEC/CANCEL]/
[INC/OK] keys, the [DATA] encoder, or the <PageUp>/<Page-
Down> keys of a PS/2 keyboard. When adjusting a parameter
that has a wide range of adjustment, you can increase the rate
of change by holding down the [SHIFT] key while you press
the [DEC/CANCEL]/[INC/OK] keys (or turn the [DATA]
encoder).
Operating section
3
29