Inserting An External Device Into A Channel; Connecting An External Device For Insertion - Yamaha DSP5D Owner's Manual

Inserting an external device into a channel

You can insert an effect processor or other external device into the signal route of an input channel or output channel. When
doing so, you can specify for each channel the input/output port and insert I/O point that you want to use for insertion.
Connecting an external device for
insertion
When inserting an external device into a desired channel,
you can use the rear panel input/output jacks or the input/
output jacks of an I/O card installed in a slot as insert-out/
insert-in jacks.
The following diagrams show typical examples of insert
connections.
Insert connection example
2 1
3
COAXIAL AES/EBU AES/EBU COAXIAL
DIGITAL IN
(AES/EBU)
Effect processor
Insert connection example
MY8-AD96
ANALOG OUT
Effect processor
1
2 1
3
AES/EBU AES/EBU
DIGITAL OUT
(AES/EBU)
2
MY8-DA96
ANALOG IN
PM5D/PM5D-RH V2 / DSP5D Owner's Manual
Insert connection example
Special AES/EBU
cable for MY8-AE
INPUT 1/2
(female)
DIGITAL OUT
(AES/EBU)
Effect processor
If you are inserting an external digital device via a digital I/
O card as shown in "Insert connection example
will need to synchronize the word clock of the PM5D and
the external device. Normally, we recommend that you set
the external device as a word clock slave, and make it fol-
low the PM5D's word clock. (For details on how to set
your device as a word clock slave, refer to its manual.)
Hint
For the PM5D model, you can also use the rear panel
INSERT IN/OUT jacks to insert an external device into an
input signal, as an alternative to the method described above.
In this case, the insert I/O point is fixed at immediately before
AD conversion. Also, the steps described p.78 will not be
necessary.
Operating section
3
8
AES/EBU
MY8-AE
OUTPUT 1/2
(male)
DIGITAL IN
(AES/EBU)
3 ," you
77