Output View Function; Ch View (Channel View) Screen - Yamaha DSP5D Owner's Manual

OUTPUT VIEW function

OUTPUT VIEW function

CH VIEW (Channel view) screen

This screen displays the mix parameters of the currently
selected MIX channel, MATRIX channel, or STEREO A/B
channel. In this screen you can also edit the principal
parameters and access other screens.
CH VIEW
A Channel
This is the number of the channel you are editing. If
the corresponding MIX/MATRIX channel is paired (or
if a STEREO A/B channel is selected), a heart symbol is
displayed at the right. You can click this symbol to
enable/disable pairing for the MIX/MATRIX channel.
Note
The screen shown above is for when a paired channel is
selected. If the selected channel is not paired, the parameters
for only one channel are displayed, and pairing-related set-
tings are not displayed.
B EQ
This area shows the post-EQ level, the approximate EQ
response, and the EQ on/off status. You can click the
EQ ON/OFF button to switch EQ on/off in this screen.
270
PM5D/PM5D-RH V2 / DSP5D Owner's Manual
If you click the mini-graph, the EQ PARAM screen for
that channel will appear.
C Compressor
This area shows the amount of gain reduction and the
output level of the compressor, a mini-graph showing
the approximate response of the compressor, and the
compressor on/off status. You can click the COMP
ON/OFF button to switch the compressor on/off in
this screen. If you click the mini-graph, the COMP
PARAM screen for that channel will appear.
D Insert in
This area indicates the insert point, the insert on/off
status, and the type and input level of the port that is
patched to insert-in. You can click the INSERT ON/
OFF button to switch insertion on/off in this screen.
If an internal effect is patched, the effect type and
BYPASS button are displayed. If a GEQ module is
patched, the GEQ ON/OFF button and a mini-graph
showing the GEQ response are displayed.
1
2
3
4
E DELAY
In this area you can view and edit the delay time of the
internal delay and its on/off status.
F TO MATRIX (only for MIX channels and
STEREO A/B channels)
This area shows the send level, send position, and on/
off status of the signals sent from the corresponding
MIX channel or STEREO A/B channel to MATRIX
buses 1–8. You can also edit the send level, send posi-
tion, and on/off status in this screen. Here's how to do
this.
• To edit the send level of signals sent to the MATRIX
bus
Move the cursor to the desired bar graph in the list,
and turn the [DATA] encoder.
• To edit the send position of signals sent to the
MATRIX bus
Click either the PRE FADER, the POST FADER, or the
POST ON button located below.
Alternatively, you can edit the setting by moving the
cursor to the PRE or POST indication in the list and
pressing the [ENTER] key or turning the [DATA]
encoder.
Reference section
5
6