Yamaha DSP5D Owner's Manual page 39

PM5D
These settings select the PM5D's inter-
nal clock. If you select one of these set-
tings, the PM5D will operate as the
INT 96, INT 88.2,
word clock master. As necessary,
INT 48, INT 44.1
make settings within your external
devices so that they will operate as
word clock slaves.
The PM5D will follow the word clock
W.CLOCK IN signal being input from the rear panel
WORD CLOCK IN connector.
The PM5D will follow the clock data
CASCADE IN being sent from another PM5D con-
nected to the CASCADE IN connector.
The PM5D will follow the clock data
2TR IN D1–D3 included in the input signal from 2TR
IN DIGITAL jacks 1–3.
The PM5D will follow the clock data
included in the input signal from a digi-
tal I/O card installed in slots 1–4. (You
SLOT 1–4
can select a specific pair of adjacent
odd-numbered/even-numbered chan-
nels.)
DSP5D
These settings select the DSP5D's
internal clock. If you select one of these
settings, the DSP5D will operate as the
INT 96, INT 88.2,
word clock master. As necessary,
INT 48, INT 44.1
make settings within your external
devices so that they will operate as
word clock slaves.
The DSP5D will follow the word clock
W.CLOCK IN signal being input from the front panel
WORD CLOCK IN connector.
CASCADE IN The DSP5D will follow the clock data
(D-sub half-pitch sent from the other DSP5D, the PM5D,
68-pin connector) or the DME64N.
The DSP5D will follow the clock data
CASCADE IN
sent from the other DSP5D or the
(RJ-45 connector)
DCU5D.
The DSP5D will follow the clock data
included in the input signal from a digi-
tal I/O card installed in slots 1–2. (You
SLOT 1–2
can select a specific pair of adjacent
odd-numbered/even-numbered chan-
nels.)
Note
• Sources for which the symbol at the left of the button is
red (UNLOCK) or yellow (UNKNOWN) cannot be selected,
since a valid clock is not being input or the clock cannot be
detected.
• If the PM5D and DSP5D are cascade-connected via the
DCU5D and you're not synchronizing to an external word
clock being input to the PM5D, you should set the PM5D as
the word clock master and the DSP5D as the slave. This
means that in this case, you'll select INT for the PM5D, and
CASCADE IN for the DSP5D.
2 In the MASTER CLOCK SELECT area located in
the upper part of the screen, click a button to
select the desired master clock source.
A window will appear, asking you to confirm that you
want to switch the master clock.
3 Click the OK button.
The selected word clock master will be enabled. The
selected word clock master is remembered even if you
turn off the power. As long as the connections have not
been changed, you don't have to make this setting
again.
Note
• If a digital I/O card (such as the MY8-AE96S) that contains a
• If transferring high sampling rate (88.2 kHz/96 kHz) signals
PM5D/PM5D-RH V2 / DSP5D Owner's Manual
built-in SRC (Sampling Rate Converter) is installed in slots,
you can switch the SRC on/off in groups of two channels.
The input signals from channels for which the SRC is turned
on do not need to be synchronized with the PM5D/DSP5D's
word clock.
between the PM5D/DSP5D and an external device, you will
need to select the transmission method. (For details, refer to
p.220)
Operating section
4
39