Yamaha DSP5D Owner's Manual page 129

If you set a value to SW, ENC, or FAD, that value will
be linked to the state of the controller. For example if
you have made settings as shown in the following
screen, the last value will be linked with the fader posi-
tion, and will change in the range of 0–127.
When you click a box in which a hexadecimal value has
been input, the range of values that can be interpreted
as a valid MIDI message (including that box) will turn
red. The lower part of the screen shows the MIDI chan-
nel (MIDI CH), message type (TYPE), and data values
(DATA 1, DATA 2) for this MIDI message, letting you
verify that the appropriate MIDI message has been
input.
You can use the following buttons to input or edit the
message in this window.
buttons Move the highlighted area to left or right.
Inserts a space (blank) at the highlighted
position. Pressing the <Insert> key of a
INS button
PS/2 keyboard will produce the same
result.
Deletes the character at the highlighted
position. Pressing the <Delete> key of a
DEL button
PS/2 keyboard will produce the same
result.
Erases the entire message that was input
CLEAR button
in the MIDI message input boxes.
Pastes the message that was copied to
PASTE button
buffer memory by the COPY button.
Copies the message from the MIDI mes-
sage input box to temporary buffer mem-
COPY button ory. Use this in conjunction with the PASTE
button to copy a message from one con-
troller to another bank or controller.
When you have finished inputting data in the MIDI
REMOTE SETUP window, click the OK button. The
hexadecimal values will be input in the MIDI message
box of the MIDI REMOTE screen.
Hexadecimal values that were input
B Specifying the type of message
In this method you specify the desired MIDI channel,
type of message, and data value; these will be con-
verted into the appropriate hexadecimal values. Access
the MIDI REMOTE SETUP window in the same way
as for method
you want to input data.
Next, click the
TYPE box to select the type of message.
Then use the MIDI CH, DATA 1, and DATA 2 boxes
to specify the MIDI channel and various values. The
values that can be selected in the MIDI CH, DATA 1,
and DATA 2 boxes will depend on the type of message
you selected first.
NOTE OFF
NOTE ON
KEY PRES-
SURE
CONTROL
CHANGE
PROGRAM
CHANGE
CHANNEL
PRESSURE
PITCH BEND
EXCLUSIVE
MESSAGE
If you set the DATA 1 or DATA 2 value to SWITCH,
ENCODER (available only for encoders), or FADER
(available only for faders), that value will be linked with
the state of the controller.
PM5D/PM5D-RH V2 / DSP5D Owner's Manual
1 , and click the first box into which
/ buttons at the left and right of the
Type of message
TYPE MIDI CH DATA 1
Note number
(0–127)
Control num-
1–16
ber (0–127)
Program
number
Pressure
value (0–127)
Pitch bend
MSB (0–127)
—
Operating section
DATA 2
Note-off velocity
(0–127)
Note-on velocity
(0–127)
Pressure value
(0–127)
Controller value
(0–127)
16
—
Pitch bend LSB
(0–127)
129