Audio Connections; Analog Audio Connections - Yamaha DSP5D Owner's Manual

Digital mixing console/digital mixing system
Hide thumbs Also See for DSP5D:
Table of Contents

Advertisement

Audio connections

Analog audio connections

PM5D model
Synthesizer
Effect processor
INPUT jacks 1–48 are used mainly to connect micro-
phones or monaural line-level devices. ST IN jacks 1–4 are
used mainly to connect stereo line-level devices.
Input signal sensitivity, pad on/off, and phantom power
(+48V) on/off are controlled from the top panel AD IN
section (➥ p.44).
PM5D-RH model
Synthesizer
Microphone
INPUT jacks 1–48 and ST IN jacks 1–4 can both be used to
connect microphones or line-level devices.
Input signal sensitivity and phantom power (+48V) on/off
are controlled from within the display (➥ p.44). However,
all phantom power can be switched on/off as a whole by
the rear panel [+48V MASTER] switch.
DSP5D
Microphone
INPUT jacks 1–48 and ST IN jacks 1–4 will accommodate
connections ranging from microphones to line level
devices.
Each connector is provided with phantom power (+48V),
and the input signal sensitivity and phantom power on/off
can be operated from the display as on the PM5D-RH
(➥ p.44). The +48V master switch is turned on/off in the
SYS/W.CLOCK function MIXER SETUP screen
(➥ p.221).
Microphone
PM5D/PM5D-RH V2 / DSP5D Owner's Manual
Microphone
When the PM5D, PM5D-RH, or DSP5D are in the
default state, the input signal from INPUT jacks 1–48 is
patched to input channels 1–48, and the input signal
from ST IN jacks 1–4 is patched to the ST IN channels.
However, you may change this if desired (for details on
restoring the default patching ➥ p.40).
Operating section
Synthesizer
4
33

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pm5d-rh v2Pm5dPm5d-rhPm5d v2Pm5d-ex

Table of Contents