Yamaha DSP5D Owner's Manual page 378

Warning Messages
Message
Parameter Locked.
Parameter Unlocked.
This Parameter is Locked.
Channel Copied.
Channel Pasted.
Nothing to Paste!
Cannot Paste to Different Channel Type.
No Card in Slot!
File Already Exist!
Saving Aborted.
Loading Aborted.
No Controllable Gain.
Tap Operation Ignored.
Cascade Unit Disconnected.
Additional Cascade Unit Detected.
Incorrect Cascade Connection!
Couldn't Store Scene on Slave Console!
Couldn't Edit Scene on Slave Console!
DME Disconnected.
No Response from External HA.
Processing Aborted.
Internal Power Supply is Turned On.
Illegal Address!
Load Locked.
Load Unlocked.
DME Unsupported Firmware Version.
DME Unsupported Component Version.
DME DSP Power Shortage.
Corrupted data fixed!
Parameter out of range!
Channel Moved.
378
PM5D/PM5D-RH V2 / DSP5D Owner's Manual
Parameter Lock has been enabled.
Parameter Lock has been defeated.
The parameter you attempted to control is locked.
The selected channel settings were copied to the memory buffer.
The channel settings in the memory buffer were pasted to the selected channel.
Paste cannot be performed because there is no data in the memory buffer.
Paste cannot be performed because you are attempting to paste channel settings of a different type.
No memory card is inserted in the MEMORY CARD slot.
The memory card already contain a file/directory with the same name as the one you are attempting to
save, rename, or create.
Saving to memory card was aborted.
Loading from memory card was aborted.
You attempted to operate a gain knob that is currently disabled on the panel.
Tap operation was ignored because the TAP TEMPO button is not displayed in the screen.
The connection with a cascade-connected external device was broken.
A cascade-connected external device was newly detected.
The connection is not appropriate for the cascade settings.
The cascade-connected slave console was unable to store the scene because the scene was protected on
the slave console, or for some other reason.
The cascade-connected slave console was unable to edit the scene because the scene was protected on
the slave console, or for some other reason.
The connection with an external DME was broken.
No response from an external AD8HR or AD824.
A process was aborted.
(DSP5D only) The internal power supply started up normally.
(DSP5D only) The IP address or gateway address setting is invalid.
LOAD LOCK is on, and file loading from memory card is prohibited.
LOAD LOCK is off, and file loading from memory card is possible.
A DME operating with an unsupported firmware version was connected.
A DME containing a component of an unsupported version was connected.
The DSP resources of the DME are insufficient.
Illegal parameter values that exceeded the valid range have been correct to stay within the allowable
range.
While reading from a memory card, there was a parameter value that exceeded the allowable range.
Channel settings have been moved between the selected channels.
Reference section
Meaning